Previously, we have introduced the process of precision hardware parts, so today our chief engineer of Ruicheng Precision Hardware will share with you the precautions in the processing of precision hardware parts:

1. Check whether the moving part is filled with lubricant before the precision hardware parts processing machine works, then start and check whether the clutch and brake are normal, and idle the machine for 1-3 minutes. Operations are strictly forbidden when the precision hardware parts processing machine fails.

2. Keep the correct posture while working, and have enough spirit to cope with the work. If you find that you are not well, you should leave the job immediately and report to the leader. When operating, concentrate on thinking, forbid chatting, cooperate with each other. Operators should not operate in a state of irritability and fatigue, so as to avoid it.

Accidents occur to ensure safe operation. Before entering the job, all employees check whether their clothes meet the requirements of the job. Slippers, high heels and clothing that affect safety are not allowed to wear. Safety hats should be worn for long hair.

3. When replacing the die, first turn off the power supply. After the movement Department of the punch stops running, the die can be installed and debugged. After installation and adjustment, the flywheel is tested twice by hand to check whether the upper and lower dies are symmetrical and reasonable, whether the screw is firm, and whether the blank holder ring is in a reasonable position.

4. When all other personnel leave the mechanical workspace and take away the debris on the workbench, they can start the power-on machine.

5. When the precision hardware parts processing machinery works, it is forbidden to extend the hand into the slider working area, and it is forbidden to take and place the parts by hand. Use standard tools when drawing and placing workpieces in the die. If abnormal sound or machine failure is found, the power switch should be switched off immediately for inspection.
When the machine is started, one person will transport material and operate it mechanically. Others may not press the power or pedal on the switch board, let alone put their hands in the working area of the machine or touch the moving part of the machine with their hands.

6. When leaving work, the idle power supply should be turned off and the finished products, materials and sundries on the post should be sorted out to ensure the clean and safe working environment.