Nowadays, with the continuous improvement of science and technology, our industry needs to use a variety of processing, in the process of processing, we will inevitably have a variety of problems, or we need to comply with the problem, Dongguan CNC parts processing is one of them, then CNC parts processing should pay attention to what problems?

1. Comply with the safety operation rules of the machining center.

2. Protective articles should be worn well before work, cuffs should be tied well, scarves, gloves, ties and aprons should not be worn, and women workers'braids should be tied in hats.

3. Check the correctness of tool compensation, machine tool zero and workpiece zero before starting.

4. The relative position of each button should meet the operation requirements. Seriously compile and input numerical control program.

5. To check the operation status of hunger protection, insurance, signal, position, mechanical transmission, electrical and hydraulic digital display systems on the equipment, cutting can be carried out under all normal conditions.

6. Before CNC parts are processed, the machine tool should be tested for lubrication, mechanical, electrical, hydraulic and digital display systems. Cutting can be carried out under normal conditions.

7. After the machine tool enters the processing operation according to the program, the operator is not allowed to contact the workpiece, cutter and transmission part of the mover. It is forbidden to transfer or take tools and other items across the transmission part of the machine tool.

When adjusting machine tools, clamping workpieces and cutting tools, and cleaning machine tools, stop.

9. Tools or other articles shall not be placed on electrical appliances, operating cabinets and protective covers.

10. No direct removal of iron chips by hand should be allowed. Special tools should be used for cleaning.

11. If abnormal conditions and alarm signals are found, stop and ask the relevant personnel to check. CNC Machining Center.

12. Do not leave the work station while the machine is turning. If you want to leave, put the worktable in the middle, return the cutter rod, stop, and cut off the power supply of the main engine.